如果不使用CLI?看看这个能不能初始化:
Starting the Initial Configuration WizardProcedureStep 1 Boot the AP that has controller capability.
It will be a few minutes before the
CiscoAirProvision SSID starts broadcasting after initially powering up the AP. Once the
CiscoAirProvision SSID starts broadcasting, the AP's status LED start cycling through green, red, and amber.
Step 2 Connect the Wi-Fi-enabled laptop to the
CiscoAirProvision SSID advertised by the AP, using Wi-Fi. The password is
password.The laptop gets an IP address from the subnet 192.168.1.0/24.
Step 3 Open a supported web browser and enter the URL
mobilityexpress.cisco to reach the initial configuration wizard. The wizard starts by asking you to create an admin account.
On Apple clients, after connecting to the
CiscoAirProvision SSID, the captive portal window may automatically open with the initial configuration wizard. You can use this window itself complete the initial configuration without opening a web browser.
Note After connecting to the
CiscoAirProvision SSID, upon opening a web browser you should be automatically redirected to
mobilityexpress.cisco. If you are not automatically redirected, then you can manually enter the URL
mobilityexpress.cisco or go to
http://192.168.1.1, both of which redirect to the initial configuration wizard.
https://www.cisco.com/c/en/us/td/docs/wireless/access_point/mob_exp/83/user_guide/b_ME_User_Guide_83/b_ME_User_Guide_83_chapter_01000.html#task_273F476C3AEA4F56B207CD62A80051E3
~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~
Rps-Cheers | If it solves your problem, please mark as answer. Thanks !