取消
显示结果 
搜索替代 
您的意思是: 
cancel
5353
查看次数
0
有帮助
8
回复

问题-接入交换机上联口err

ming63626
Level 1
Level 1
接入交换机上联级联口由于loopback detect 被置为err状态 请问有可能是什么原因?一般不是只会ERR接入端口么?
8 条回复8

duxiulei
Level 1
Level 1
查一下生成树吧

YilinChen
Spotlight
Spotlight
环路了呀,查生成树,errdisable状态是好事,没造成更大的影响,建议仔细梳理一下拓扑:lol

fortune
VIP Alumni
VIP Alumni
show int sta err 就能查看到什么原因,然后根据原因来处理,如果不需要的话我建议你关闭这个detect

niweijian2014
Spotlight
Spotlight
如果没什么影响,或者这个报错出现频率不高的话,楼主可以忽视它

levi_z
Level 1
Level 1
思科文档对loopback detect errdisable 解析:
A loopback error occurs when the keepalive packet is looped back to the port that sent the keepalive. The switch sends keepalives out all the interfaces by default. A device can loop the packets back to the source interface, which usually occurs because there is a logical loop in the network that the spanning tree has not blocked. The source interface receives the keepalive packet that it sent out, and the switch disables the interface (errdisable).
原因就是链路发现环路,交换机自动将端口进入err状态。
active:
排查链路是什么原因导致环路.一般是链路接线错误或者上联设备有环路导致的。
恢复方法:
确认环路原因后,端口shutdown/no shutdown 就可以恢复。

cruiseluo
Spotlight
Spotlight
1、在versions 12.2SE之后,交换机的fiber端口和uplink端口默认没有设置 keepalive,所以首先要show一下你的交换机上联级联口,看是否有类似"Keepalive set (10 sec)"的语句。如果有,那么该端口就会由于loopback detect 被置为err状态。
2、cisco交换机至少有两种机制封掉出现loopback的端口,一种是生成树机制,一种是端口的Keepalive机制

wenwen ji
Level 1
Level 1
双上连口吗?这个有可能是线路不稳定,环路等问题,尝试看一下logg日志。或者重启,或者把端口shutdown.
再看一下问题。

sh666666
Level 10
Level 10
0. 提供的信息太少。
1. 检查逻辑环,查看并设计spanning tree吧。
2. 检查配置中的keepalive的设置。
入门指南

使用上面的搜索栏输入关键字、短语或问题,搜索问题的答案。

我们希望您在这里的旅程尽可能顺利,因此这里有一些链接可以帮助您快速熟悉思科社区:









快捷链接