返修后的2960,用户名密码不知道

[pp888]

原来可能是供电不稳,出现橙灯闪烁,返修后应该是换了主板,
返修后回来不知道密码?
尝试按住mode键再接电源,但还是正常启动进入?
大神知道怎么恢复出厂设置?恢复密码?或者是返修后的思科一般设什么密码?

[YilinChen]

本帖最后由 YilinChen 于 2017-12-19 13:56 编辑
断电重启时，一直按住MOD键，直到LED灯由琥珀色变成绿色，才能放开；同时注意观察console提示；
1. Connect a terminal or PC with terminal-emulation software to the switch console port.
2. Set the line speed on the emulation software to 9600 baud.
3. Power off the switch.
4. Reconnect the power cord to the Switch or the stack master. Within 15 seconds, press the Mode button while the System LED is still flashing green. Continue pressing the Mode button until the System LED turns briefly amber and then solid green; then release the Mode button.
If you see a message that begins with this, proceed to the Procedure with Password Recovery Enabled section, and follow the steps.
The system has been interrupted prior to initializing the flash file system. The
following commands will initialize the flash file system
If you see a message that begins with this, proceed to the Procedure with Password Recovery Disabled section, and follow the steps.
The password-recovery mechanism has been triggered, but is currently disabled.
5. After recovering the password, reload the switch.
参考链接地址：
https://www.cisco.com/c/en/us/td ... FC29D04313BF07CFFBC

[Jim—Jin]

参考链接：https://supportforums.cisco.com/t5/lan-switching-and-routing/cisco-switch-2960-3560-gt-password-recovery-and-factory-default/td-p/2064791

[fortune]

按久一点 , MODE

[何康林]

应该是你按mode键时间不够