本帖最后由 kevinpop1 于 2018-7-24 09:39 编辑
一直没有找到机会重启路由器,今天测试了一下,用boot启动也是不行。
下面是抓的log,麻烦帮助看一下,感觉有些不对,在confreg那里
**********************************************************
* *
* Welcome to Rom Monitor for WS-X45-SUP6L-E System *
* Copyright (c) 2003-2011 by Cisco Systems, Inc. *
* All rights reserved. *
* *
**********************************************************
Checking the partition table and boot sector...
Checking FAT, Files and Directories...
Reclaiming unused space...
Updating FAT...
Rom Monitor Program Version 12.2(44r)SG10
CPU Rev: 2.1, Board Rev: 12, Board Type: 103, CPLD Nexu Rev: 12
Chassis: WS-C4503-E
Front Panel Phy is Bcm5482s
Got Mac Address: 58:8d:09:d9:e2:db
MAC Address : 58-8d-09-d9-e2-db
Ip Address : Not set.
Netmask : Not set.
Gateway : Not set.
TftpServer : Not set.
Peer supervisor not detected or is not running IOS
Supervisor uplinks and all linecards have been reset
***** The system will autoboot in 5 seconds *****
Type control-C to prevent autobooting.
Autoboot cancelled......... please wait!!!
Autoboot cancelled......... please wait!!!
rommon 1 > [interrupt]
rommon 1 > [interrupt]
rommon 1 >dir
usage: dir { [ bootflash: ] | [ slot0: ] | [ usb0: ] }
rommon 2 >dir bootflash:
File Size (Bytes) File Name
---------------------------------------
24086230 cat4500e-lanbase-mz.150-2.SG1.bin
Total space = 128282624 bytes, Available = 101625856 bytes
rommon 3 >dir usb0:
The device has either been removed or bad device name usb0:
usage: dir { [ bootflash: ] | [ slot0: ] | [ usb0: ] }
rommon 4 >dir slot0:
File slot0: not present //这里看到三个设备,只有bootflahs:上面有个系统文件,奇怪的config没见到
rommon 5 >meminfo
Main memory size: 512 MB.
NVRAM size: 512KB
rommon 6 >version
Rom Monitor Program Version 12.2(44r)SG10
Compiled Mon 14-Mar-11 10:02 by andrao-k5rommon_122_44r_SG10
Supervisor: WS-X45-SUP6L-E Chassis: WS-C4503-E
CPU Rev: 2.1, Board Rev: 12, Board Type: 103
CPLD Nexu Rev: 12, FPGA Darkside Rev: 4, Installed memory: 512 MBytes
rommon 7 >confreg 0x2142
usage: confreg 怎么感觉这里像是报错了
rommon 8 >confreg ?
usage: confreg
rommon 9 >conf history
1 dir
2 dir bootflash:
3 dir usb0:
4 dir slot0:
5 meminfo
6 version
7 confreg 0x2142
8 confreg ?
9 history
rommon 10 >boot //加电修改寄存器之后,这里用boot重启
Rommon reg: 0x00004380
Reset2Reg: 0x00008EFF
#
Darkside controller 0x0B46EA76..0x0B47CE28 original size:0x00012092##
Fortooine controller 0x0B5A753F..0x0B70B6D1 original size:0x001C3EA5
##################
diagsk5 version 5.0.1
prod: WS-X45-SUP6L-E part: 73-13067-03 serial: JAE1544011L
Power-on-self-test for Module 1: WS-X45-SUP6L-E
CPU Subsystem Tests ...
seeprom: Pass
Traffic: L3 Looopback ...
Test Results: Pass
Traffic: L2 Loopback ...
Test Results: Pass
Switching Subsystem Memory ...
Packet Memory Test Results: Pass
Module 1 Passed
Rommon reg: 0x00000380
###############################################################
Restricted Rights Legend
Use, duplication, or disclosure by the Government is
subject to restrictions as set forth in subparagraph
(c) of the Commercial Computer Software - Restricted
Rights clause at FAR sec. 52.227-19 and subparagraph
(c) (1) (ii) of the Rights in Technical Data and Computer
Software clause at DFARS sec. 252.227-7013.
cisco Systems, Inc.
170 West Tasman Drive
San Jose, California 95134-1706
Cisco IOS Software, Catalyst 4500 L3 Switch Software (cat4500e-LANBASE-M), Version 15.0(2)SG1, RELEASE SOFTWARE (fc4)
Technical Support: http://www.cisco.com/techsupport
Copyright (c) 1986-2011 by Cisco Systems, Inc.
Compiled Thu 25-Aug-11 07:54 by prod_rel_team
Image text-base: 0x10000000, data-base: 0x128BE57C
cisco WS-C4503-E (MPC8548) processor (revision 12) with 524288K bytes of memory.
Processor board ID FOX1551G0LB
MPC8548 CPU at 1GHz, Supervisor 6L-E
Last reset from PowerUp
1 Virtual Ethernet interface
52 Gigabit Ethernet interfaces
2 Ten Gigabit Ethernet interfaces
511K bytes of non-volatile configuration memory.
Press RETURN to get started!
*Jul 23 16:43:14.019: %SPANTREE-5-EXTENDED_SYSID: Extended SysId enabled for type vlan
*Jul 23 16:43:14.719: %C4K_IOSMODPORTMAN-6-MODULEONLINE: Module 1 (WS-X45-SUP6L-E S/N: JAE1544011L Hw: 3.0) is online
*Jul 23 16:43:14.719: %C4K_IOSMODPORTMAN-6-MODULEONLINE: Module 2 (WS-X4648-RJ45-E S/N: JAE152002EE Hw: 1.0) is online
*Jul 23 16:43:16.963: %SYS-5-CONFIG_I: Configured from memory by console
*Jul 23 16:43:17.263: %SYS-5-RESTART: System restarted --
Cisco IOS Software, Catalyst 4500 L3 Switch Software (cat4500e-LANBASE-M), Version 15.0(2)SG1, RELEASE SOFTWARE (fc4)
Technical Support: http://www.cisco.com/techsupport
Copyright (c) 1986-2011 by Cisco Systems, Inc.
Compiled Thu 25-Aug-11 07:54 by prod_rel_team
C4503>en
Password:
*Jul 23 16:43:33.331: %C4K_GLMMAN-3-X2PLUGGABLESEEPROMREADFAILED: Failed to read seeprom on port Te1/1. Reinsert X2 module or configure GigabitEthernet port group if TwinGigConverter is installed.
*Jul 23 16:43:33.331: %C4K_GLMMAN-3-X2PLUGGABLESEEPROMREADFAILED: Failed to read seeprom on port Te1/2. Reinsert X2 module or configure GigabitEthernet port group if TwinGigConverter is installed.
% Password: timeout expired!
Password:
Password:
% Bad secrets //这里重启之后依然不能进入特权模式
C4503>show ver
Cisco IOS Software, Catalyst 4500 L3 Switch Software (cat4500e-LANBASE-M), Version 15.0(2)SG1, RELEASE SOFTWARE (fc4)
Technical Support: http://www.cisco.com/techsupport
Copyright (c) 1986-2011 by Cisco Systems, Inc.
Compiled Thu 25-Aug-11 07:54 by prod_rel_team
Image text-base: 0x10000000, data-base: 0x128BE57C
ROM: 12.2(44r)SG10
Darkside Revision 4, Nexu Revision 12, Fortooine Revision 1.32
C4503 uptime is 1 minute
System returned to ROM by power-on
System image file is "bootflash:cat4500e-lanbase-mz.150-2.SG1.bin"
cisco WS-C4503-E (MPC8548) processor (revision 12) with 524288K bytes of memory.
Processor board ID FOX1551G0LB
MPC8548 CPU at 1GHz, Supervisor 6L-E
Last reset from PowerUp
27 Virtual Ethernet interfaces
52 Gigabit Ethernet interfaces
2 Ten Gigabit Ethernet interfaces
511K bytes of non-volatile configuration memory.
--More-- Configuration register is 0x2101
//这里看到的寄存器还是0x2101,等于是0x2142没有修改成功
C4503>