取消
显示结果 
搜索替代 
您的意思是: 
cancel
3450
查看次数
0
有帮助
6
回复

ASA5515 port-channel

seasonli72658
Spotlight
Spotlight
Cisco Adaptive Security Appliance Software Version 9.6(3)1
Device Manager Version 7.9(2)152
Compiled on Thu 30-Mar-17 21:40 PDT by builders
System image file is "disk0:/asa963-1-smp-k8.bin"
Config file at boot was "startup-config"
ASA5515-SH-new up 8 days 14 hours
Hardware: ASA5515, 8192 MB RAM, CPU Clarkdale 3058 MHz, 1 CPU (4 cores)
ASA: 4110 MB RAM, 1 CPU (1 core)
Internal ATA Compact Flash, 8192MB
BIOS Flash MX25L6445E @ 0xffbb0000, 8192KB
ASA5515和3650交换机可不可以做port-channel呢,因为做了一次是失败的,配置如下:
ASA5515:

interfacePort-channel2
no switchport
ip address10.99.201.1 255.255.255.248

interfaceGigabitEthernet0/0
nameif inside1
security-level 100
channel-group 2 mode active
policy-routeroute-map rmap-to-Liantong
interfaceGigabitEthernet0/5
nameif inside1
security-level 100
channel-group2 mode active
policy-routeroute-map rmap-to-Liantong

SW-3650

interfacePort-channel2

no switchport

ip address10.99.201.4 255.255.255.248



interfaceGigabitEthernet1/0/18

no switchport

no ip address

channel-group 2 modeactive


interfaceGigabitEthernet2/0/18

no switchport

no ip address

channel-group 2 modeactive

不知道这样写配置是不是可以的呢,有哪里需要更改呢


6 条回复6

ghkjobs
Level 1
Level 1
你是port-channel 不能起来是?还是聚合不生效问题?

seasonli72658
Spotlight
Spotlight
ghkjobs@163.com 发表于 2019-10-15 10:49
你是port-channel 不能起来是?还是聚合不生效问题?

起来不生效

EtherChannel Guidelines
You can configure up to 48 EtherChannels.
Each channel group can have eight active interfaces. Note that you can assign up to 16 interfaces to a channel group. While only eight interfaces can be active, the remaining interfaces can act as standby links in case of interface failure.
All interfaces in the channel group must be the same type and speed. The first interface added to the channel group determines the correct type and speed.
The device to which you connect the ASA EtherChannel must also support 802.3ad EtherChannels; for example, you can connect to the Catalyst 6500 switch.
The ASA does not support LACPDUs that are VLAN-tagged. If you enable native VLAN tagging on the neighboring switch using the Cisco IOS vlan dot1Q tag native command, then the ASA will drop the tagged LACPDUs. Be sure to disable native VLAN tagging on the neighboring switch. In multiple context mode, these messages are not included in a packet capture, so you cannot diagnose the issue effectively.
The ASA does not support connecting an EtherChannel to a switch stack. If the ASA EtherChannel is connected cross stack, and if the Master switch is powered down, then the EtherChannel connected to the remaining switch will not come up.
All ASA configuration refers to the logical EtherChannel interface instead of the member physical interfaces.
You cannot use a redundant interface as part of an EtherChannel, nor can you use an EtherChannel as part of a redundant interface. You cannot use the same physical interfaces in a redundant interface and an EtherChannel interface. You can, however, configure both types on the ASA if they do not use the same physical interfaces.
You cannot use interfaces on the 4GE SSM, including the integrated 4GE SSM in slot 1 on the ASA 5550, as part of an EtherChannel.
~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~
Rps-Cheers | If it solves your problem, please mark as answer. Thanks !

liu_zhimin
Spotlight
Spotlight
把channel-group 2 modeactive改成 channel-group 2 mode on应该就正常了

seasonli72658
Spotlight
Spotlight
1540488497lcj 发表于 2019-10-15 14:14
EtherChannel Guidelines
You can configure up to 48 EtherChannels.

Hi
All ASA configuration refers to the logical EtherChannel interface instead of the member physical interfaces.
You cannot use a redundant interface as part of an EtherChannel, nor can you use an EtherChannel as part of a redundant interface. You cannot use the same physical interfaces in a redundant interface and an EtherChannel interface. You can, however, configure both types on the ASA if they do not use the same physical interfaces.
这段话的意思没太理解,能详细解释一下吗,最后有个例子,感谢

fortune
VIP Alumni
VIP Alumni
一般情况我们都是配置为ON的模式
入门指南

使用上面的搜索栏输入关键字、短语或问题,搜索问题的答案。

我们希望您在这里的旅程尽可能顺利,因此这里有一些链接可以帮助您快速熟悉思科社区:









快捷链接