本帖最后由 1540488497lcj 于 2019-2-20 11:03 编辑 a\LAP镜像转换为ME镜像,方法如下,
AP3820.5686.3AB0#ap-type mobility-express tftp://10.1.1.100/AIR-AP1830-K9-8.2.100.0.tar
b\ME AP
在LAP 命令行下输入如下命令下载并转换为CAPWAP镜像
archive download-sw /reload tftp://10.1.1.100/ap1g4-k9w8-tar.153-3.JC.tar
注意:启动了AP后,正常最终进入Controller CLI界面。
命令行执行apciscoshell 进入LAP 命令行,
(Cisco Controller) >apciscoshell
提示信息,
!!Warning!!: You are entering ap shell. This will stop you from establishing new telnet/SSH/Web sessions to controller.
Also the exsisting sessions will be suspended till you exit the ap shell.
To exit the ap shell, use 'logout'
User Access Verification
Username: admin
Password:
AP3820.5686.3AB0>en
AP3820.5686.3AB0#ap-type capwap
~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~
Rps-Cheers | If it solves your problem, please mark as answer. Thanks !