本帖最后由 kpak00001 于 2016-4-27 17:51 编辑
如题,交换机的物理接口有正常的数据收发,为什么5分钟的入站和出站速率为 0?
GigabitEthernet4/0/38 is up, line protocol is up (connected)
Hardware is Gigabit Ethernet, address is 001b.0cc7.ed63 (bia 001b.0cc7.ed63)
MTU 1500 bytes, BW 1000000 Kbit, DLY 10 usec,
reliability 255/255, txload 1/255, rxload 0/255
Encapsulation ARPA, loopback not set
Keepalive set (10 sec)
Full-duplex, 1000Mb/s, media type is 10/100/1000BaseTX
input flow-control is off, output flow-control is unsupported
ARP type: ARPA, ARP Timeout 04:00:00
Last input 00:00:26, output 00:00:00, output hang never
Last clearing of "show interface" counters 1w0d
Input queue: 0/75/0/0 (size/max/drops/flushes); Total output drops: 0
Queueing strategy: fifo
Output queue: 0/0 (size/max)
5 minute input rate 0 bits/sec, 0 packets/sec
5 minute output rate 0 bits/sec, 0 packets/sec
5869192169 packets input, 5350680989870 bytes, 0 no buffer
Received 20387 broadcasts (20387 multicasts)
0 runts, 0 giants, 0 throttles
2 input errors, 2 CRC, 0 frame, 0 overrun, 0 ignored
0 watchdog, 20387 multicast, 0 pause input
0 input packets with dribble condition detected
4751941448 packets output, 1402945972605 bytes, 0 underruns
0 output errors, 0 collisions, 0 interface resets
0 babbles, 0 late collision, 0 deferred
0 lost carrier, 0 no carrier, 0 PAUSE output
0 output buffer failures, 0 output buffers swapped out