Cisco Unified Communications Manager Administrator Web GUI 1 From the Product Specific Configuration Layout area of the device configuration window, enable Wipe Device. 2 Issue an Apply Config, Restart, or Reset command from the Admin GUI to push the wipe to the device.
方法二：
Settings application 1 In the Settings application, choose Backup & reset > Factory data reset. Note：If a PIN or Password is configured on the device, it will need to be entered before the reset can proceed.
方法三：
Key-press sequences Follow these steps to reset a
Cisco DX70
on boot up: 1 Power on the device and wait for the Mute LED to blink. 2 Press and hold the Volume Up button until the Mute button is lit red. 3 Release the Volume Up button, then press and hold the Mute button for 3 seconds. Follow these steps to reset a
Cisco DX80
on boot up: 1 Press and hold the Volume Up button and power on the device. 2 Release the Volume Up button when the Mute button is lit red, then press the Mute button. Follow these steps to reset a
Cisco DX650
on boot up: 1 Press and hold the # key and power on the device. 2 When the Message Waiting Indicator (MWI) flashes red once then stays lit, release the # key.
