本帖最后由 L3511604172 于 2019-3-27 22:28 编辑 命令行操作如下:
On wlc1:
config interface address redundancy-management redundancy-mgmt-ip-addr-wlc1 peer-redundancy-management peer-redundancy-mgmt-ip-addr-wlc2 -------配置冗余管理接口;
config redundancy unit primary/secondary ----配置HA角色;
config redundancy mode sso -----启用SSO功能,协商角色;
On wlc2:
config interface address redundancy-management redundancy-mgmt-ip-addr-wlc2 peer-redundancy-management peer-redundancy-mgmt-ip-addr-wlc1
config redundancy unit secondary
config redundancy mode sso
连接两个wlc的RP端口,然后重启两台设备。
show redundancy summary ------确认HA状态;
具体官方文档,参考如下:
https://www.cisco.com/c/en/us/td ... 50B9028D38956C32BAF